Lucent Technologies SLC ConnectReach User & Service Manual page 106

®
Configuring the SLC ConnectReach
Using the Configuration Commands
Basic Procedure For Using the
Configuration Commands (Continued)
Activating new
configuration
settings
4-20 Issue 4 June 2002
™
System
Some commands are activated and take effect as soon as you enter the save
command, but others require that you reboot the SLC ConnectReach system,
using either the warm-start or cold-start command, before the new
settings take effect. The following table indicates which commands require a
reboot to take effect and which type of reboot is required.
Commands Requiring the Save Command to Take Effect:
Analog Trunk Channel Bank
DS0-Provisioning* (all commands except
ConnectReach and Analog-begin)
Firewall Lines
NTP Password
Synchronous-
Interface: changing IP
addressing SYSLOG
Commands Requiring the Save and Warm-Start Commands to Take Effect:
Default DHCP
Network-T1 other than
Clock Preserve-Default
Set-Features Synchronous-Interface (All commands except IP addressing)
Commands Requiring the Save and Cold-Start Commands to Take Effect:
ARP ConnectReach
DS0-Provisioning* HTTP Port
*
DS0-Provisioning command requires the Save and Cold-Start commands if the begin channel
value in any of the ranges is changed. Otherwise, use only the Save command.
To reboot the SLC ConnectReach system, enter the appropriate command at the
Main Menu prompt:
> warm-start
or
> cold-start
Dialing Digital Trunk
Ethernet (all commands except IP or
secondary-IP)
Map-Extensions NAT/PAT
QOS RS-232
template-archive Voice-Mail
Ethernet (IP or
DNS (enable on/off) secondary-IP)
Secondary-T1 or
Route Fractional-T1
Cross-connect (channel-bank submenu);
Network-T1 Clock
SNMP (enabling/
disabling, changing
host) Telnet Port
(Continued on next page)
363-208-050