Configuring Destination; Table 332: Destination Configuration Details - Juniper NETWORK AND SECURITY MANAGER 2010.4 - M-SERIES AND MX-SERIES DEVICES GUIDE REV 1 Manual

M-series and MX-series Devices

Configuring Destination

Table 332: Destination Configuration Details

Option Function
System > Accounting > Destination > Radius
Enable Feature Enables to configure the radius feature of the
destination option.
532
To configure the accounting feature:
In the NSM navigation tree, select Device Manager > Devices.
1.
Click the Device Tree tab, and then double-click the device for which you want to
2.
configure the accounting feature.
Click the Configuration tab. In the configuration tree, select System > Accounting.
3.
Enter a comment in the Accounting workspace that describes the accounting.
4.
Click one:
5.
OK—Saves the changes.
Cancel—Cancels the modifications.
Apply—Applies the accounting parameters.
You can configure the following options with accounting feature:
Configuring Destination on page 532
Configuring Events on page 534
Configuring Traceoptions on page 534
To configure destination:
In the NSM navigation tree, select Device Manager > Devices.
1.
Click the Device Tree tab, and then double-click the device for which you want to
2.
configure the destination.
Click the Configuration tab. In the configuration tree, select System > Accounting >
3.
Destination.
Select the Enable Feature check box to enable this feature.
4.
Enter a comment in the Destination workspace that describes the destination.
5.
Add or modify settings as specified in Table 332 on page 532.
6.
Click one:
7.
OK—Saves the changes.
Cancel—Cancels the modifications.
Apply—Applies the destination settings.
Your Action
Select the Enable Feature check box to enable
this feature.
Copyright © 2010, Juniper Networks, Inc.