Table of Contents
Advertisement
M-series and MX-series Devices
484
Add or modify the settings as specified in Table 291 on page 484.
5.
Click one:
6.
OK—To save the changes.
Cancel—To cancel the modifications.
Table 291: Traffic Management Configuration Details
Task
Configure the maximum
burst size for RTP/RTCP
gate streams.
Configure the peak data rate
for RTP/RTCP gate streams.
Your Action
1.
Click Add new entry next to Gateway.
2. Click H248 Properties next to gateway.
3. Expand H248 Properties.
4. Click Traffic Management next to H248 properties.
5. In the Comment box, enter the comment.
6. Click Max Burst Size next to Traffic Management.
7. In the Comment box, enter the comment.
8. From the Default list, select the default maximum burst size.
Range: 20 through 2147483647 bytes
9. Expand Maximum Burst Size.
10. Click Rtcp next to Maximum Burst Size.
11. In the Comment box, enter the comment.
12. Expand Rtcp.
13. Click Percentage next to Rtcp.
14. Select one of the following:
percentage—if the value entered is a percentage of the RTP
gate's rate.
fixed-value—if the value entered is a fixed number of bytes
per second.
Range: 20 through 2147483647 bytes-per-second
1.
Click Peak Data Rate next to Traffic Management.
2. In the Comment box, enter the comment.
3. From the Default list, select the default peak data rate.
Range: 125 through 2147483647 bytes per second
4. Expand Peak Data Rate.
5. Click Rtcp next to Peak Data Rate.
6. In the Comment box, enter the comment.
7. Expand Rtcp.
8. Click Percentage next to Rtcp.
9. Select one of the following:
percentage—if the value entered is a percentage of the
RTP's gate rate.
fixed-value—if the value entered is a fixed number of bits
per second.
Range: 0 through 2147483647
Copyright © 2010, Juniper Networks, Inc.
Advertisement
Table of Contents
