Juniper NETWORK AND SECURITY MANAGER 2010.4 - M-SERIES AND MX-SERIES DEVICES GUIDE REV 1 Manual page 129

Copyright © 2010, Juniper Networks, Inc.
Table 43: Igmp Snooping Configuration Details (continued)
Task
Enable IGMP on an interface
and configure
interface-specific properties.
Configuring IGMP snooping
proxy mode.
Your Action
1. Click Interface next to Igmp Snooping.
2. Click Add new entry next to Interface.
3. In the Name box, enter the interface name.
4. In the Comment box, enter the comment.
5. Select the Multicast Router Interface check box if the interface
is a multicast router interface.
6. Select the Immediate Leave check box to enable immediate
leave on a router.
7. Select the Host Only Interface check box if the interface is to
be configured as a host-facing interface.
8. From the Group Limit list, select the limit for the number of
multicast groups (or [S,G] channels in IGMPv3) allowed on an
interface.
After this limit is reached, new reports will be ignored and all
related flows are not flooded on the interface.
9. Click Static next to interface.
10. In the Comment box, enter the comment.
11. Expand Static.
12. Click Group next to Static.
13. Click Add new entry next to Group.
14. In the Name box, enter the IGMP multicast group address.
15. In the Comment box, enter the comment.
16. Click Source next to group.
17. Click Add new entry next to Source.
18. In the Name box, enter the IP version 4 (IPv4) unicast source
address for the multicast group being statically configured on
an interface.
19. In the Comment box, enter the comment.
1. Click Proxy next to Igmp Snooping.
2. In the Comment box, enter the comment.
3. In the Source Address box, enter the IP address to use as the
source for IGMP snooping reports in proxy mode.
Chapter 10: Configuring Bridge Domains
93