Configuring Forwarding Options (Nsm Procedure); Table 233: Packet Filter Configuration Details - Juniper NETWORK AND SECURITY MANAGER 2010.4 - M-SERIES AND MX-SERIES DEVICES GUIDE REV 1 Manual

M-series and MX-series Devices

Table 233: Packet Filter Configuration Details

Option
Name
Comment
Protocol
Source Prefix
Destination Prefix
Source Port
Destination Port
Interface
Related
Documentation

Configuring Forwarding Options (NSM Procedure)

400
Cancel—Cancels the modifications.
Apply—Applies the packet filter settings.
Function
Specifies the trace packet filter name.
Supplies a descriptive comment for the packet
filter.
Specifies the match IP protocol type.
Specifies the source IPv4 address prefix.
Specifies the destination IPv4 address prefix.
Specifies the match TCP/UDP source port.
Specifies the match TCP/UDP destination port.
Specifies the logical Interface.
Configuring Certificates (NSM Procedure) on page 390
Configuring the Firewall Authentication (NSM Procedure) on page 392
Configuring the Forwarding Options (NSM Procedure) on page 400
To configure forwarding options:
In the NSM navigation tree, select Device Manager > Devices.
1.
Click the Device Tree tab, and then double-click the device for which you want to
2.
configure forwarding options.
Click the Configuration tab. In the configuration tree, select Security > Forwarding
3.
Options.
Enter a comment in the Forwarding Options workspace that describes the forwarding
4.
options.
In the configuration tree, select Security > Forwarding Options > Family.
5.
Enter a comment in the Family workspace that describes the family.
6.
Configure the options as specified in Table 234 on page 401.
7.
Click one:
8.
OK—Saves the changes.
Your Action
Enter a name.
(Optional) Enter a comment.
Select the protocol type from the list.
Enter the source IPv4 address prefix.
Enter the destination IPv4 address prefix.
Select the source port from the list.
Select the destination port from the list.
Select the interface from the list.
Copyright © 2010, Juniper Networks, Inc.