Modeling Devices Overview; Adding Multiple Devices Using Automatic Discovery (Junos Software Devices - Juniper NETWORK AND SECURITY MANAGER 2010.4 - M-SERIES AND MX-SERIES DEVICES GUIDE REV 1 Manual

M-series and MX-series Devices
Related
Documentation

Modeling Devices Overview

28
NOTE: After importing a device configuration, log entries from that device
begin to appear in the Log Viewer. However, until you update the device from
NSM, the following log fields display 0 (or unknown):
domain
rulebase
policy
rule number
source zone
destination zone
After you update the imported device configuration using NSM, the
appropriate values are displayed for log entries from the device.
When you import a device configuration, the Log Viewer displays the
appropriate values for the device's log entries. This feature eliminates the
need to update the device after importing it.
For more detailed information about adding and importing devices with static and dynamic
IP addresses and verifying imported device configurations, see "Adding Devices" in the
Network and Security Manager Administration Guide.
About Device Creation on page 25
Supported Add Device Workflows for M-series and MX-series Devices on page 26
Modeling Devices Overview on page 28
Adding Multiple Devices Using Automatic Discovery (JUNOS Software Devices Only)
on page 29
Adding Device Groups Overview on page 29
For an undeployed M-series or MX-series device, you can create a device configuration
in NSM, and then install that device configuration on the physical device.
Adding a single undeployed device to NSM is a four-stage process:
Model the device in the UI.
1.
Create the device object configuration.
2.
Activate the device.
3.
Update the device configuration.
4.
Copyright © 2010, Juniper Networks, Inc.