Changing Encoding Defaults (Nsm Procedure); Configuring Service Change (Nsm Procedure); Table 278: H248 Configuration Details; Table 279: Encoding Defaults Configuration Details - Juniper NETWORK AND SECURITY MANAGER 2010.4 - M-SERIES AND MX-SERIES DEVICES GUIDE REV 1 Manual

Copyright © 2010, Juniper Networks, Inc.

Table 278: H248 Configuration Details

Task
Configure options that affect
virtual BGF H.248 behavior.

Changing Encoding Defaults (NSM Procedure)

You can change the encoding defaults using this option.
To configure encoding defaults in NSM:
In the navigation tree select Device Manager > Devices.
1.
In the Devices list, double-click the device to select it.
2.
In the Configuration tab, expand Services > Pgcp.
3.
Select Gateway.
4.
Add or modify the settings as specified in Table 279 on page 469.
5.
Click one:
6.
OK—To save the changes
Cancel—To cancel the modifications

Table 279: Encoding Defaults Configuration Details

Task
Change encoding defaults.

Configuring Service Change (NSM Procedure)

Service change specifies the method and reason that the virtual BGF includes in
ServiceChange commands that it sends to the gateway controller when the state of a
control association, virtual interface, or context changes. See the following topics:
Configuring Context Indications (NSM Procedure) on page 470
Configure Control Association Indications (NSM Procedure) on page 470
Configuring Virtual Interface Indications (NSM Procedure) on page 473
Your Action
1. Click Add new entry next to Gateway.
2. Click H248 Options next to gateway.
3. In the Comment box, enter the comment.
4. Select the Audit Observed Events Returns option to enable
a history of media inactivity events to be viewed by the
gateway controller.
Your Action
1. Click Add new entry next to Gateway.
2. Click H248 Options next to gateway.
3. Expand H248 Options.
4. Click Encoding next to H248 Options.
5. In the Comment box, enter the comment.
6. Select the No Dscp Bit Mirroring check box to disable mirroring
of DSCP bits.
7. Select the Use Lower Case check box to configure upper-case
encoding for H.248 messages.
Chapter 23: Configuring Services
469