Juniper NETWORK AND SECURITY MANAGER 2010.4 - M-SERIES AND MX-SERIES DEVICES GUIDE REV 1 Manual page 533

Copyright © 2010, Juniper Networks, Inc.
Table 303: Service Set Configuration Details (continued)
Task
Specify the Packet Gateway
Control Protocol (PGCP)
rules or rule set included in
this service set.
Configuring the policy
decision statistics profile.
Define the order in which
services are applied for this
service set.
Specify the stateful firewall
rules or rule set included in
this service set.
Your Action
1. Click Pgcp Rules next to service-set.
2. Select one of the following:
pgcp-rules—To specify the pgcp rules included in this service
set.
pgcp-rule-set—To specify the pgcp rule set included in this
service set.
3. Click Add new entry.
4. From the Name list, select the rule or rule set name.
5. In the Comment box, enter the comment.
1. Click Policy Decision Statistics Profile next to service-set.
2. In the Comment box, enter the comment.
3. From the Profile Name list, select the policy decision statistics
profile.
1. Click Service Order next to service-set.
2. In the Comment box, enter the comment.
3. Click Forward Flow next to Service Order.
4. Click Add new entry next to Forward Flow.
5. In the New forward-flow window, enter the service order for
forward flow.
6. Click Reverse Flow next to Service Order.
7. Click Add new entry next to Reverse Flow.
8. In the New reverse-flow window, enter the service order for
reverse flow.
1. Click Stateful Firewall Rules next to service-set.
2. Select one of the following:
stateful-firewall-rules—To specify the stateful firewall rules.
stateful-firewall-rule-sets—To specify the stateful firewall
rule set.
3. Click Add new entry.
4. From the Name list, select the rule or rule set name.
5. In the Comment box, enter the comment.
Chapter 23: Configuring Services
497