Configuring Msdp Peers (Nsm Procedure) - Juniper NETWORK AND SECURITY MANAGER 2010.4 - M-SERIES AND MX-SERIES DEVICES GUIDE REV 1 Manual

M-series and MX-series Devices
326
Table 178: Peer Group Configuration Details (continued)
Task
Apply one or more policies
to routes being imported
into the routing table from
MSDP.

Configuring MSDP Peers (NSM Procedure)

An MSDP router must know which routers are its peers. You define the peer relationships
explicitly by configuring the neighboring routers that are the MSDP peers of the local
router. After peer relationships are established, the MSDP peers exchange messages to
advertise active multicast sources. You must configure at least one peer for MSDP to
function.
To configure MSDP peers in NSM:
In the NSM navigation tree, select Device Manager > Devices.
1.
Click the Device Tree tab, and then double-click the device to select it.
2.
Click the Configuration tab. In the configuration tree, expand Protocols.
3.
Select Msdp.
4.
Add or modify settings as specified in Table 179 on page 327.
5.
Click one:
6.
OK—Saves the changes.
Cancel—Cancels the modifications.
Your Action
1. Click Import next to Group.
2. Use the following options to select the policies to import:
Click Add after selecting a policy member from the Non
member list to add it to the Members list.
Click Remove after selecting a policy from the Members list
to remove it from the Members list.
Click Add All to add all the Non members to the Members
list.
Click Remove All to remove all the members from the
Members list.
Copyright © 2010, Juniper Networks, Inc.