Juniper NETWORK AND SECURITY MANAGER 2010.4 - M-SERIES AND MX-SERIES DEVICES GUIDE REV 1 Manual page 266

M-series and MX-series Devices
230
Table 117: Inet6 Family Configuration Details (continued)
Task
Configure output filter.
Apply a policer to an
interface.
Check whether traffic is
arriving on an expected path.
Configure the direction of
traffic to be sampled.
Your Action
1. Click Output next to Filter.
2. Select one of the following:
Select output to configure name of one filter to evaluate
when packets are transmitted on the interface. Enter the
output filter name.
a. Enter the output filter name.
Select output-list to apply a group of filters to evaluate
when packets are transmitted on an interface.
a. Click Add new entry next to output-list.
b. In the New output-list window, enter the filter names.
Up to 16 filters can be included in a filter input list.
1. Click Policer next to Filter.
2. In the Comment box, enter the comment.
3. In the Input box, enter the name of one policer to evaluate
when packets are received on the interface.
4. In the Output box, enter the name of one policer to evaluate
when packets are transmitted on the interface.
1. Click Rpf Check next to Inet.
2. In the Comment box, enter he comment.
3. In the Fail Filter box, enter the filter name to evaluate when
packets are received on the interface.
4. Click Mode next to Rpf Check.
5. In the Comment box, enter the comment.
6. Select the loose check box to check whether the packet has
a source address with a corresponding prefix in the routing
table.
1. In the Comment box, enter the comment.
2. Select the Input check box to configure at least one expected
ingress point.
3. Select the Output check box to configure at least one
expected egress point.
Copyright © 2010, Juniper Networks, Inc.