Table of Contents
Advertisement
Related
Documentation
Configuring PGCP (NSM Procedure)
Copyright © 2010, Juniper Networks, Inc.
Table 273: NAT Configuration Details (continued)
Task
Specify the rule set the
router uses when applying
this service.
Configuring Adaptive Services PICs (NSM Procedure) on page 431
Configuring PGCP (NSM Procedure) on page 463
You can use the Packet Gateway Control Protocol (PGCP) options to configure the Border
Gateway Function. See the following topics:
Configuring Gateway (NSM Procedure) on page 464
Configuring H248 Options Properties (NSM Procedure) on page 468
Configuring H248 Properties (NSM Procedure) on page 474
Configuring H248 Timers (NSM Procedure) on page 485
Configuring the Monitor (NSM Procedure) on page 486
Configuring Overload Control (NSM Procedure) on page 487
Configuring Session Mirroring (NSM Procedure) on page 488
Configuring Media Service (NSM Procedure) on page 488
Configuring a Rule (NSM Procedure) on page 489
Configuring Rule Set (NSM Procedure) on page 490
Configuring Session Mirroring (NSM Procedure) on page 490
Configuring Traceoptions (NSM Procedure) on page 491
Configuring Virtual Interface (NSM Procedure) on page 492
Your Action
1.
Click Rule Set next to Nat.
2. Click Add new entry next to Rule Set.
3. In the Name box, enter an identifier for the collection of rules
that constitute this rule set.
4. In the Comment box, enter the comment.
5. Expand rule-set.
6. Click Rule next to rule-set.
7. Click Add new entry next to Rule.
8. From the Name list, select the identifier for the collection of
terms that comprise this rule.
9. In the Comment box, enter the comment.
Chapter 23: Configuring Services
463
Advertisement
Table of Contents
