Juniper NETWORK AND SECURITY MANAGER 2010.4 - M-SERIES AND MX-SERIES DEVICES GUIDE REV 1 Manual page 448

M-series and MX-series Devices
Table 243: VPN Configuration Details (continued)
Option
Comment
Algorithm
vpn > Manual > manual > Encryption > Key
Comment
vpn > Manual > manual > Encryption > Key > Ascii Text
None
ascii-text
hexadecimal
vpn > Manual > ike
Comment
Gateway
Idle Time
No Anti Replay
Ipsec Policy
Install Interval
vpn > Manual > ike > Proxy identity
Enable Feature
Comment
Local
Remote
412
Function
Supplies a descriptive comment for the encryption
option.
Defines the encryption algorithm.
Specifies a descriptive comment for the encryption
key.
Specifies that neither the ascii-text or hexadecimal
key is enabled.
Enables the ASCII text key.
Enables the hexadecimal text key.
Specifies a descriptive comment for the IKE.
Specifies the remote gateway name.
Specifies the idle time to remove Secure
Authentication (SA).
Disable the snit-reply check.
Specifies the name of the IPsec policy.
Delays the installation of re-entered outbound SAs
on the initiator.
Enables the proxy identity feature.
Specifies a descriptive comment for the proxy
identity option.
Specifies the local IP address.
Specifies the remote IP address.
Your Action
(Optional) Enter a comment.
Select the Algorithm from the list.
(Optional) Enter a comment.
Select the option.
Select the option and enter the ASCII text
key.
Select the option and enter the hexadecimal
text key.
Enter a comment.
Select the gateway from the list.
Set the idle time. Range: 60 - 999999.
Select the No Anti Replay check box.
Select the IPsec policy from the list.
Set the duration of the installation. Range: 1
- 10.
Select the Enable Feature check box to
enable this feature.
(Optional) Enter a comment.
Enter the IP address.
Enter the IP address.
Copyright © 2010, Juniper Networks, Inc.