Table of Contents
Advertisement
Related
Documentation
Configuring the SecurID Server (NSM Procedure)
Copyright © 2010, Juniper Networks, Inc.
Table 27: RADIUS Server Configuration Details
Task
Configure the RADIUS
servers.
Configuring the RADIUS Parameters (NSM Procedure) on page 68
You can configure the securid server using the Securid Server option.
To configure the SecurID server in NSM:
In the NSM navigation tree, select Device Manager > Devices.
1.
Click the Device Tree tab, and then double-click the device to select it.
2.
Click the Configuration tab. In the configuration tree, expand Access.
3.
Select Securid Server.
4.
Add or modify settings as specified in Table 28 on page 72.
5.
Click one:
6.
OK—Saves the changes.
Cancel—Cancels the modifications.
Your Action
1.
Click Add new entry next to Radius Server
2. In the Name box, enter the profile name.
3. In the Comment box, enter the comment.
4. From the Accounting Port list, select the port number on which
to contact the accounting server.
Default: 1813 (as specified in RFC 2865)
5. From the Port list, select the port number on which to contact
the RADIUS server.
Default: 1812 (as specified in RFC 2865)
6. In the Secret box, enter the password to use with the RADIUS
server. The secret password used by the local router must
match that used by the server.
7. From the Timeout list, select the amount of time that the local
router waits to receive a response from a RADIUS server.
Range: 1 through 90 seconds
Default: 3 seconds
8. From the Retry list, select the number of times that the router
is allowed to attempt to contact a RADIUS server.
Range: 1 through 10
Default: 3
9. In the Source Address box, enter a valid IPv4 address
configured on one of the router interfaces.
10. From the Routing Instance list, select the routing instance
name.
Chapter 7: Configuring Access
71
Advertisement
Table of Contents
