Table of Contents
Advertisement
Related
Documentation
Configuring a Domain Search (NSM Procedure)
Related
Documentation
Configuring Extensions (NSM Procedure)
Copyright © 2010, Juniper Networks, Inc.
Apply—Applies the diag port authentication settings.
Configuring a Domain Search (NSM Procedure)
Configuring a Backup Router (NSM Procedure) on page 539
Configuring Extensions (NSM Procedure) on page 541
You can configure the name of the domain in which the clients search for a dynamic host
configuration protocol (DHCP) server host. The domain name is appended to hostnames
that are not fully qualified. If you do not configure a domain name, the default is the
client's current domain. The domain search sets the order in which the clients append
domain names when searching for the IP address of a host. You can include one or more
domain names in the list.
To configure a domain search:
In the NSM navigation tree, select Device Manager > Devices.
1.
Click the Device Tree tab, and then double-click the device for which you want to
2.
configure the domain search.
Click the Configuration tab. In the configuration tree, select System > Domain Search.
3.
Click + to enter a new domain search name.
4.
Click one:
5.
OK—Saves the changes.
Cancel—Cancels the modifications.
Apply—Applies the domain search settings.
Configuring a Backup Router (NSM Procedure) on page 539
Configuring Extensions (NSM Procedure) on page 541
Configuring a Diag Port Authentication (NSM Procedure) on page 540
The extensions feature allows you to configure the providers and the resource limits.
To configure extensions:
In the NSM navigation tree, select Device Manager > Devices.
1.
Click the Device Tree tab, and then double-click the device for which you want to
2.
configure the extensions feature.
Click the Configuration tab. In the configuration tree, select System > Extensions.
3.
Chapter 25: Configuring System
541
Advertisement
Table of Contents
