Juniper NETWORK AND SECURITY MANAGER 2010.4 - M-SERIES AND MX-SERIES DEVICES GUIDE REV 1 Manual page 459

Table 252: Interface Configuration Details (continued)
Option
Name
Comment
Allow Incoming
interface > Proxy Arp
Comment
interface > Proxy Arp > Address
Name
Comment
interface > Proxy Arp > Address Range
Low
High
Comment
interface > Source Nat
Comment
interface > Source Nat >
Pool
Name
Comment
Host Address Low
No Port Translation
Allow Incoming
interface > Source Nat >
Pool
Copyright © 2010, Juniper Networks, Inc.
Function
Specifies the name of the interface.
Supplies a descriptive comment for the interface.
Allows the interface pool to support the incoming
traffic.
Supplies a descriptive comment for the proxy
Address Resolution Protocol (ARP).
Specifies the address prefix.
Supplies a descriptive comment for the address
prefix. This is optional.
Specifies the lower limit of the address range.
Specifies the upper limit of the address range.
Supplies a descriptive comment for the address
range.
Supplies a descriptive comment for the source NAT.
> pool
Specifies the pool name.
Supplies a descriptive comment for the source NAT
pool.
Specifies the lower limit of the host address.
Specifies that the port translation is not performed.
Allows the pool to support incoming traffic.
> pool > Address
Chapter 22: Configuring Security
Your Action
Select the name from the drop-down list.
(Optional) Enter a comment.
Select the Allow Incoming check box to
enable this feature.
(Optional) Enter a comment.
Enter the address prefix.
Enter a comment.
Enter the lower limit of the address range.
Enter the upper limit of the address range.
(Optional) Enter a comment.
(Optional) Enter a comment.
Enter the pool name.
(Optional) Enter a comment.
Enter the lower limit of the host address.
Select the No Port Translation check box
to enable this feature.
Select the Allow Incoming check box to
enable this feature.
423