Table of Contents
Advertisement
Copyright © 2010, Juniper Networks, Inc.
Add or modify the settings as specified in Table 276 on page 467.
5.
Click one:
6.
OK—To save the changes.
Cancel—To cancel the modifications.
Table 276: Gateway Controller Configuration Details
Task
Configure a gateway
controller.
Configuring Graceful Restart (NSM Procedure)
You can configure graceful restart properties that are used during synchronization between
the pgcpd process and the Multiservices PIC or DPC.
To configure graceful restart in NSM:
In the navigation tree select Device Manager > Devices.
1.
In the Devices list, double-click the device to select it.
2.
In the Configuration tab, expand Services > Pgcp.
3.
Select Gateway.
4.
Add or modify the settings as specified in Table 277 on page 468.
5.
Click one:
6.
OK—To save the changes.
Cancel—To cancel the modifications.
Your Action
1.
Click Add new entry next to Gateway.
2. Click Gateway Controller next to gateway.
3. Click Add new entry next to Gateway Controller.
4. In the Name box, enter the name of the gateway controller or
BSG.
5. In the Comment box, enter the comment.
6. In the Controller Address box, enter the IP address of the
gateway controller.
7. From the Controller Port list, select the port number of the
gateway controller.
Range: 0 through 65535
8. Expand gateway-controller.
9. Click Interim Ah Scheme.
10. In the Comment box, enter the comment.
11. From the Algorithm list, select the algorithm used for the
interim AH scheme.
HMAC null is currently the only algorithm supported
Chapter 23: Configuring Services
467
Advertisement
Table of Contents
