Configuring The Firewall Filter For Bridge Family Type (Nsm Procedure); Table 79: Bridge Filter Configuration Details - Juniper NETWORK AND SECURITY MANAGER 2010.4 - M-SERIES AND MX-SERIES DEVICES GUIDE REV 1 Manual

Configuring the Firewall Filter for Bridge Family Type (NSM Procedure)

Copyright © 2010, Juniper Networks, Inc.
Configuring the Firewall Filter for Ccc Family Type (NSM Procedure) on page 165
Configuring Filters for inet Family Type (NSM Procedure) on page 167
On the MX-series router, you can filter Layer 2 packets in a bridging environment using
this option.
In the NSM navigation tree, select Device Manager > Devices.
1.
Click the Device Tree tab, and then double-click the device to select it.
2.
Click the Configurationtab. In the configuration tree, expand Firewall > Family >
3.
Bridge.
Add or modify settings as specified in Table 79 on page 163.
4.
Click one:
5.
OK—Saves the changes.
Cancel—Cancels the modifications.

Table 79: Bridge Filter Configuration Details

Task
Configure firewall filters for
Layer 2 packets that are part
of bridging domain for MX
series routers.
Configure accounting for
firewall filter.
Your Action
1. Click Filter next to Bridge.
2. Click Add new entry next to Filter.
3. Expand Filter.
4. In the name box, enter the name that identifies the filter.
5. In the Comment box, enter the comment.
6. Select Interface Specific to configure interface-specific names
for firewall counters.
1. Click Accounting Profile next to filter.
2. In the New accounting-profile window, enter the name to be
assigned to the accounting profile.
Chapter 15: Configuring Firewall
163