Configuring Sip Policies And Timers (Nsm Procedure); Table 262: Service Point Configuration Details - Juniper NETWORK AND SECURITY MANAGER 2010.4 - M-SERIES AND MX-SERIES DEVICES GUIDE REV 1 Manual

Copyright © 2010, Juniper Networks, Inc.

Table 262: Service Point Configuration Details

Task
Configure a service point.
Configure service classes for
the embedded SPDF.
Assign new call usage
policies or policy sets to the
service point.

Configuring SIP Policies and Timers (NSM Procedure)

See the following topics:
Configuring Message Manipulation Rules (NSM Procedure) on page 438
Configuring New Call Usage Policy (NSM Procedure) on page 439
Your Action
1. Click Add new entry next to Gateway.
2. Click Service Point next to gateway.
3. Click Add new entry next to Service Point.
4. In the Name box, enter the name.
5. In the Comment box, enter the comment.
6. From the Service Point Type list, select the type of VoIP
protocol for this service point.
Values: sip
7. From the Service Interface list, select the name of the service
interface.
8. From the Default Media Realm list, select the realm number
used to match to a virtual interface
Range: 0 through 1023
1. Click Service Class next to Embedded Spdf.
2. From the Service Interface list, select the name and logical
unit number of the Multiservices PIC or DPC.
3. Click Add new entry next to Service Class.
4. In the Name box, enter the identifier for the service class.
5. In the Comment box, enter the comment.
1. Click Service Policies next to service-point.
2. In the Comment box, enter the comment.
3. Click New Call Usage Policies next to Service Policies.
4. Click Add new entry next to New Call Usage Policies.
5. In the New new-call-usage-policies window, enter the names
of new call usage policies or policy sets.
Syntax: If you specify more than one policy or policy set, you
must enclose all policy names in brackets.
6. Click New Transaction Policies next to Service Policies.
7. Click Add new entry next to New Transaction Policies.
8. In the New new-transaction-policies window, enter the names
of new call usage policies or policy sets.
Syntax: If you specify more than one policy or policy set, you
must enclose all policy names in brackets.
9. Click Transport Details next to service-point.
10. In the Comment box, enter the comment.
11. From the Port Number list, select the port number.
12. In the Ip Address box, enter the IP address.
13. Select the corresponding transport protocol.
Chapter 23: Configuring Services
437