Configuring Interfaces; Chapter 17 Configuring Interfaces; Configuring Interfaces On The Routing Platform (Nsm Procedure); Configuring Interface Properties (Nsm Procedure) - Juniper NETWORK AND SECURITY MANAGER 2010.4 - M-SERIES AND MX-SERIES DEVICES GUIDE REV 1 Manual

CHAPTER 17

Configuring Interfaces

Configuring Interfaces on the Routing Platform (NSM Procedure)

Configuring Interface Properties (NSM Procedure)

Copyright © 2010, Juniper Networks, Inc.
Configuring Interfaces on the Routing Platform (NSM Procedure) on page 209
Configuring Interface set on the Routing Platform (NSM Procedure) on page 236
Configuring Trace Options on the Routing Platform (NSM Procedure) on page 237
You can configure the interfaces on the router using this option. See the following topics:
Configuring Interface Properties (NSM Procedure) on page 209
Damping Interface Transitions (NSM Procedure) on page 211
Configuring Receive Bucket Properties on Interfaces (NSM Procedure) on page 212
Configuring Tracing Operations of an Individual Router Interface (NSM
Procedure) on page 212
Configuring Transmit Leaky Bucket Properties (NSM Procedure) on page 213
Configuring Logical Interface Properties (NSM Procedure) on page 214
Configuring Protocol Family Information for the Logical Interface (NSM
Procedure) on page 217
Configuring the Traffic Shaping Profile (NSM Procedure) on page 234
You can configure interfaces on the router using this option. The management and internal
Ethernet interfaces are automatically configured. You must configure all other interfaces.
To configure interfaces in NSM:
In the NSM navigation tree, select Device Manager > Devices.
1.
Click the Device Tree tab, and then double-click the device to select it.
2.
Click the Configuration tab. In the configuration tree, expand Interfaces.
3.
Select Interface.
4.
209