Configuring Interface Routes (Nsm Procedure); Table 209: Interface Routes Fields - Juniper NETWORK AND SECURITY MANAGER 2010.4 - M-SERIES AND MX-SERIES DEVICES GUIDE REV 1 Manual

M-series and MX-series Devices

Configuring Interface Routes (NSM Procedure)

Table 209: Interface Routes Fields

Option
Comment
372
NOTE: After you make changes to a device configuration, you must push that
updated device configuration to the physical security device for those changes
to take effect. You can update multiple devices at one time. See the Updating
Devices section in the Network and Security Manager Administration Guide for
more information.
You can associate a routing table group with the device's interfaces and specify routing
tables into which interface routes are imported. To define the routing tables into which
interface routes are imported, you create a routing table group and associate it with the
device's interfaces.
To configure interface routes in NSM:
In the navigation tree, select
1.
In the list, double click the device to select it.
Devices
2.
Click the
3. Configuration
In the configuration tree, expand
4.
Select Interface Routes
5.
Add or modify the parameters as specified in Table 209 on page 372.
6.
Click one:
7.
OK—To save the changes.
Cancel—To cancel the modifications.
Apply—To apply the routing option settings.
NOTE: After you make changes to a device configuration, you must push that
updated device configuration to the physical security device for those changes
to take effect. You can update multiple devices at one time. See the Updating
Devices section in the Network and Security Manager Administration Guide for
more information.
Function
Specifies the comment for the interface
route.
Device Manager > Devices
tab.
Routing Options
.
Your Action
Enter a comment.
.
.
Copyright © 2010, Juniper Networks, Inc.