Configuring Security; Chapter 22 Configuring Security; Configuring Authentication Key Updates (Nsm Procedure) - Juniper NETWORK AND SECURITY MANAGER 2010.4 - M-SERIES AND MX-SERIES DEVICES GUIDE REV 1 Manual

CHAPTER 22

Configuring Security

Configuring Authentication Key Updates (NSM Procedure)

Copyright © 2010, Juniper Networks, Inc.
Configuring Authentication Key Updates (NSM Procedure) on page 389
Configuring Certificates (NSM Procedure) on page 390
Configuring Firewall Authentication (NSM Procedure) on page 392
Configuring a Flow (NSM Procedure) on page 393
Configuring Forwarding Options (NSM Procedure) on page 400
Configuring IKE (NSM Procedure) on page 401
Configuring IPsec (NSM Procedure) on page 408
Configuring a PKI (NSM Procedure) on page 414
Configuring NAT (NSM Procedure) on page 419
You can configure authentication key updates for the Border Gateway Protocol (BGP)
and Label Distribution Protocol (LDP) routing protocols. Authentication key updates can
occur without interrupting routing and signaling protocols such as Open Shortest Path
First (OSPF), and Resource Reservation Setup Protocol (RSVP) when configured using
this option.
To configure authentication keys in NSM:
In the NSM navigation tree, select Device Manager > Devices.
1.
Click the Device Tree tab, and then double-click the device to select it.
2.
Click the Configuration tab. In the configuration tree, expand Security.
3.
Select Authentication Key Chains.
4.
Add or modify settings as specified in Table 221 on page 390.
5.
Click one:
6.
OK-Saves the changes.
Cancel-Cancels the modifications.
389