Hanging Termination Detection (Nsm Procedure); Table 286: Event Timestamp Notification Configuration Details - Juniper NETWORK AND SECURITY MANAGER 2010.4 - M-SERIES AND MX-SERIES DEVICES GUIDE REV 1 Manual

Copyright © 2010, Juniper Networks, Inc.
OK—To save the changes.
Cancel—To cancel the modifications.

Table 286: Event Timestamp Notification Configuration Details

Task
Configure event timestamp
notification.

Hanging Termination Detection (NSM Procedure)

You can enable and configure hanging termination detection using this option.
To configure hanging termination detection in NSM:
In the navigation tree select Device Manager > Devices.
1.
In the Devices list, double-click the device to select it.
2.
In the Configuration tab, expand Services > Pgcp.
3.
Select Gateway.
4.
Add or modify the settings as specified in Table 287 on page 480.
5.
Click one:
6.
OK—To save the changes.
Cancel—To cancel the modifications.
Your Action
1. Click Add new entry next to Gateway.
2. Click H248 Properties next to gateway.
3. Expand H248 Properties.
4. Click Event Timestamp Notification next to H248 Properties.
5. In the Comment box, enter the comment.
6. From the Request Timestamp list, select whether time stamp
information is made available to the gateway controller or is
suppressed.
Select requested to enable gateway controller access to
time stamp information for notifications.
Select suppressed to disable gateway controller access to
time stamp information for notifications.
Select autonomous which is equivalent to suppressed.
Chapter 23: Configuring Services
479