Juniper NETWORK AND SECURITY MANAGER 2010.4 - M-SERIES AND MX-SERIES DEVICES GUIDE REV 1 Manual page 310

M-series and MX-series Devices
274
Table 140: LDP Configuration Details (continued)
Task
Enable an OAM ingress
policy.
Enable tracing of forwarding
equivalence classes (FECs)
for LDP LSPs.
Your Action
1. Click Ingress Policy next to Oam.
2. Click Add after selecting a policy member from the Non
member list to add it to the Members list.
3. Click Remove after selecting a policy from the Members list
to remove it from the Members list.
4. Click Add All to add all the Non members to the Members list.
5. Click Remove All to remove all the members from the Members
list.
1. Click Periodic Traceroute next to Oam.
2. In the Comment box, enter the comment.
3. From the Frequency list, select the interval between traceroute
attempts.
Range: 15 through 120 minutes
4. From the Ttl list, select the maximum time-to-live value.
Range: 1 through 255
5. From the Retries list, select the number of attempts to send
a probe to a specific node before giving up.
Range: 1 through 9
6. From the Wait list, select the wait interval before resending a
probe packet.
Range: 5 though 15 seconds
7. From the Paths list, select the maximum number of paths to
search.
Range: 1 through 255
8. In the Source box, enter the IPv4 source address to use when
sending probes.
9. From the Exp list, select the class of service to use when
sending probes.
Range: 0 through 7
10. From the Fanout list, select the maximum number of next hops
to search per node.
Range: 1 through 16
Copyright © 2010, Juniper Networks, Inc.