Table of Contents
Advertisement
Configuring a Rule (NSM Procedure)
Copyright © 2010, Juniper Networks, Inc.
Cancel—To cancel the modifications.
Table 296: Media Service Configuration Details
Task
Configure media service.
You can specify the rule that the router uses when it applies the media service.
To configure a rule in NSM:
In the navigation tree select Device Manager > Devices.
1.
In the Devices list, double-click the device to select it.
2.
In the Configuration tab, expand Services > Pgcp.
3.
Select Rule.
4.
Add or modify the settings as specified in Table 297 on page 489.
5.
Click one:
6.
OK—To save the changes.
Cancel—To cancel the modifications.
Table 297: Configuring Rule
Task
Configure a rule.
Your Action
1.
Click Add new entry next to Media Service.
2. In the Name box, enter the identifier for the media service
name.
3. In the Comment box, enter the comment.
4. In the Nat Pool box, enter the identifier for the NAT address
pool.
Your Action
1.
Click Add new entry next to Rule.
2. In the Name box, enter the identifier for the rule.
3. In the Comment box, enter the comment.
4. From the Gateway list, select the identifier of the virtual BGF.
5. Expand rule.
6. Click Media Service next to rule.
7. Click Add new entry next to Media Service.
8. In the New media-service window, enter the identifier for the
media service name.
Chapter 23: Configuring Services
489
Advertisement
Table of Contents
