Configuring The Radius For Subscriber Access Management, L2Tp, Or Ppp; Procedure); Table 26: Session Limit Configuration Details; Configuring The Radius For Subscriber Access Management, L2Tp, Or Ppp (Nsm Procedure) - Juniper NETWORK AND SECURITY MANAGER 2010.4 - M-SERIES AND MX-SERIES DEVICES GUIDE REV 1 Manual

M-series and MX-series Devices
Configuring the RADIUS for Subscriber Access Management, L2TP, or PPP (NSM

Procedure)

70
In the NSM navigation tree, select Device Manager > Devices.
1.
Click the Device Tree tab, and then double-click the device to select it.
2.
Click the Configuration tab. In the configuration tree, expand Access.
3.
Select Profile.
4.
Add or modify settings as specified in Table 26 on page 70.
5.
Click one:
6.
OK—Saves the changes.
Cancel—Cancels the modifications.

Table 26: Session Limit Configuration Details

Task
Configure the timeout
interval.
Configure a client group.
You can configure RADIUS for subscriber access management, layer 2 tunneling protocol
(L2TP), or point-to-point protocol (PPP). The servers are tried in order and in a round-robin
fashion until a valid response is received from one of the servers or until all the configured
retry limits are reached.
To configure the RADIUS server in NSM:
In the NSM navigation tree, select Device Manager > Devices.
1.
Click the Device Tree tab, and then double-click the device to select it.
2.
Click the Configuration tab. In the configuration tree, expand Access.
3.
Select Radius Server.
4.
Add or modify settings as specified in Table 27 on page 71.
5.
Click one:
6.
OK—Saves the changes.
Cancel—Cancels the modifications.
Your Action
1. Click Add new entry next to Profile.
2. Click Session Options next to Profile.
3. In the Comment box, enter the comment.
4. From the Client Idle Timeout list, select the time in minutes of
idleness after which access is denied.
Range: 1 through 255 minutes
5. From the Client Session Timeout list, select the time in minutes
since initial access after which access is denied.
1. Click Client Group next to Session Option.
2. Click Add new entry next to Client Group.
3. In the New client-group window, enter the client group.
Copyright © 2010, Juniper Networks, Inc.