Table 338: Resource Limits Configuration Details - Juniper NETWORK AND SECURITY MANAGER 2010.4 - M-SERIES AND MX-SERIES DEVICES GUIDE REV 1 Manual

Table 338: Resource Limits Configuration Details

Option Function
Name Specifies the name of the package or the process resource
limit.
Comment Supplies a descriptive comment for the package or the
process resource limit.
package/process > Resources
Enable Feature Specifies that you can enable the package or the process
resources configuration feature.
Comment Supplies a descriptive comment for the package or the
process resources.
package/process > Resources > Cpu
Comment Supplies a descriptive comment for the CPU.
Priority Specifies the highest priority level that the process can
run.
Time Specifies the maximum amount of CPU time that can be
accumulated.
package/process > Resources > File
Comment Supplies a descriptive comment for the file.
Size Specifies the maximum size of a file that can be created.
Open Specifies the maximum number of simultaneous open
files.
Copyright © 2010, Juniper Networks, Inc.
Enter a comment for the resource limits.
4.
Add or modify settings as specified in Table 338 on page 543.
5.
Click one:
6.
OK—Saves the changes.
Cancel—Cancels the modifications.
Apply—Applies the resource limits settings.
NOTE: You can configure a package or a process resource limit feature from
the below table.
Chapter 25: Configuring System
Your Action
Enter a name.
(Optional) Enter a comment.
Select the Enable Feature check box to
enable this feature.
(Optional) Enter a comment.
(Optional) Enter a comment
Set the priority value. Range:
-2147483648 - 2147483647.
Set the CPU time. Range: 0 - 2147483647.
(Optional) Enter a comment.
Enter the file size.
Set the number of open files. Range: 0 -
2147483647.
543