Configuring Cos Interfaces (Nsm Procedure); Table 64: Host Outbound Traffic Configuration Details - Juniper NETWORK AND SECURITY MANAGER 2010.4 - M-SERIES AND MX-SERIES DEVICES GUIDE REV 1 Manual

M-series and MX-series Devices
Related
Documentation

Configuring CoS Interfaces (NSM Procedure)

134
OK—Saves the changes.
Cancel—Cancels the modifications.

Table 64: Host Outbound Traffic Configuration Details

Option
Forwarding Class
Dscp Code Point
Configuring CoS Forwarding Classes (NSM Procedure) on page 129
Configuring CoS Fragmentation Maps (NSM Procedure) on page 132
Configuring CoS Traffic Control Profiles (NSM Procedure) on page 146
Configuring CoS Interfaces (NSM Procedure) on page 134
An interface is configured for optimal performance in a high-traffic network. This feature
enables you to configure interface-specific CoS properties for incoming packets.
To configure CoS interfaces in NSM:
In the navigation tree, select Device Manager > Devices.
1.
Click the Device Tree tab, and then double-click the device for which you want to
2.
configure CoS interfaces.
Click the Configuration tab. In the configuration tree, expand Class of Service.
3.
Select Interfaces.
4.
Add or modify the interfaces as specified in Table 65 on page 135.
5.
Click one:
6.
OK—Saves the changes.
Cancel—Cancels the modifications.
NOTE: After you make changes to a device configuration, you must push that
updated device configuration to the physical security device for those changes
to take effect. You can update multiple devices at one time. See the Network
and Security Manager Administration Guide for more information.
Function
Defines a forwarding class
name.
Sets the value of the DSCP
code point in the ToS field of
the packet generated by the
Routing Engine (host).
Copyright © 2010, Juniper Networks, Inc.
Your Action
In the Forwarding Class box,
enter the name for the
forwarding class.
From the Dscp Code Point list,
select the DSCP code point
value.