Configuring Link Management Protocol (Nsm Procedure) - Juniper NETWORK AND SECURITY MANAGER 2010.4 - M-SERIES AND MX-SERIES DEVICES GUIDE REV 1 Manual

Related
Documentation

Configuring Link Management Protocol (NSM Procedure)

Copyright © 2010, Juniper Networks, Inc.
Table 140: LDP Configuration Details (continued)
Task
Allow control of the
transport address used by
LDP.
Configuring the ILMI Protocol (NSM Procedure) on page 257
Configuring RSVP (NSM Procedure) on page 351
Configuring Link Management Protocol (NSM Procedure) on page 277
Link Management is a protocol used to define a forwarding adjacency between peers
and to maintain and allocate resources on the traffic engineering links. It defines the data
channel connection and the control channel connection between devices.
To configure link management in NSM:
In the navigation tree select Device Manager > Devices.
1.
In the Devices list, double-click the device to select it.
2.
In the Configuration tab, expand Protocols > Link Management.
3.
Add or modify the settings as specified in Table 141 on page 278.
4.
Click one:
5.
OK—To save the changes.
Cancel—To cancel the modifications.
Your Action
1. Click Transport Address next to Ldp.
2. In the Comment box, enter the comment.
3. Click Router Id next to Transport Address.
4. Select one of the following:
router-id—The router identifier is used as the transport
address.
interface—The first IP address on the interface is used as
the transport address.
address—IP address to be advertised as the transport
address.
Chapter 20: Configuring Protocols
277