Juniper NETWORK AND SECURITY MANAGER 2010.4 - M-SERIES AND MX-SERIES DEVICES GUIDE REV 1 Manual page 389

Copyright © 2010, Juniper Networks, Inc.
Table 200: RSVP Configuration Details (continued)
Task
Enable RSVP on one or
more router interfaces.
Your Action
1. Click Interface next to Rsvp.
2. Click Add new entry next to Interface.
3. In the Name box, enter the name of the interface.
4. In the Comment box, enter the comment.
5. Select Disable check box to explicitly disable RSVP or RSVP
graceful restart.
6. In the Authentication Key box, enter the authentication key
(password).
7. Select one of the following:
aggregate—To use RSVP aggregate messages.
no-aggregate—To not to use RSVP aggregate messages.
8. Select one of the following:
reliable—To enable reliable message delivery on the
interface.
no-reliable—To disable reliable message delivery on the
interface.
9. From the hello Interval list, select the length of time between
hello packets. A value of 0 disables the sending of hello packets
on the interface.
Range: 1 through 60 seconds
Default: 9 seconds
10. In the Bandwidth box, enter the bandwidth in bits per second.
11. From the Update Threshold list, select the percentage change
in bandwidth to trigger an Interior Gateway Protocol (IGP)
update.
Range: 1 through 60 seconds
Default: 9 seconds
Chapter 20: Configuring Protocols
353