Juniper NETWORK AND SECURITY MANAGER 2010.4 - M-SERIES AND MX-SERIES DEVICES GUIDE REV 1 Manual page 477

Copyright © 2010, Juniper Networks, Inc.
Table 264: New Call Usage Policy Configuration Details (continued)
Task
Configure match conditions
for a new call usage policy.
Your Action
1. Click From next to term.
2. In the Comment box, enter the comment.
3. Click Add new entry next to Term.
4. In the Name box, enter the identifier for the term.
5. Click Contact next to From.
6. Click Add new entry next to Contact.
7. In the Comment box, enter the comment.
8. Click Regular Expression next to contact.
9. Click Add new entry next to Regular Expression.
10. In the New regular-expression window, enter the regular
expression used to match the contents of the contact field.
Syntax: To specify more than one regular expression, enclose
the regular expressions in brackets.
11. Click Method next to From.
12. Click Add new entry next to Method.
13. From the Name list, select method-invite to match the policy
to SIP INVITE methods.
14. In the Comment box, enter the comment.
15. Click Request Uri next to From.
16. Click Add new entry next to Request Uri.
17. In the Comment box, enter the comment.
18. Click Regular Expression next to request-uri.
19. In the New regular-expression window, enter the regular
expression used to match the contents of the request URI field.
Syntax: To specify more than one regular expression, enclose
the regular expressions in brackets.
20. Click Source Address next to From.
21. Click Add new entry next to Source Address.
22. In the New source-address window, enter the IP addresses
that you want to match.
Syntax: To specify more than one IP address, enclose the IP
addresses in brackets.
Chapter 23: Configuring Services
441