Table of Contents
Advertisement
Copyright © 2010, Juniper Networks, Inc.
Table 111: Logical Unit Configuration Details
Task
Configure logical unit
properties.
Configuring an IP Demux Underlying Interface (NSM Procedure)
You can configure the logical demultiplexing (demux) destination family type on the IP
demux underlying interface.
To configure an IP demux underlying interface in NSM:
In the NSM navigation tree, select Device Manager > Devices.
1.
Click the Device Tree tab, and then double-click the device to select it.
2.
Click the Configuration tab. In the configuration tree, expand Interfaces.
3.
Select Interface.
4.
Add or modify settings as specified in Table 112 on page 216.
5.
Click one:
6.
OK—Saves the changes.
Cancel—Cancels the modifications.
Your Action
1.
Click Add Interface next to Interface.
2. In the Add Interface Dialog box, enter the interface name.
3. Click Unit next to interface.
4. Click Add new entry next to Unit.
5. From the
Name
list, select the interface name.
6. In the Comment check box, enter the comment.
7. Select the Disable check box to disable a physical or a logical
interface, effectively unconfiguring it.
8. Select the Reassemble Packets check box to enable
reassembly of fragmented tunnel packets on generic routing
encapsulation (GRE) tunnel interfaces.
9. In the Description box, enter the text to describe the interface.
If the text includes spaces, enclose the entire text in quotation
marks.
10. From the Encapsulation list, select the encapsulation type.
11. In the Bandwidth box, enter the peak rate.
12. Select one of the following:
traps—To enable the sending of Simple Network
Management Protocol (SNMP) notifications when the state
of the connection changes.
no-traps—To disable the sending of Simple Network
Management Protocol (SNMP) notifications when the state
of the connection changes.
13. From the Accounting Profile list, select the accounting profile.
Chapter 17: Configuring Interfaces
215
Advertisement
Table of Contents
