Juniper NETWORK AND SECURITY MANAGER 2010.4 - M-SERIES AND MX-SERIES DEVICES GUIDE REV 1 Manual page 301

Related
Documentation
Copyright © 2010, Juniper Networks, Inc.
Table 139: Layer2 Circuit Configuration Details (continued)
Task
Enable rewriting of the MAC
address for Layer 2 protocol
tunneling.
Define tracing options.
Configuring Link Management Protocol (NSM Procedure) on page 277
Configuring Layer 2 Address Learning and Forwarding Properties (NSM Procedure) on
page 258
Your Action
1. Click mac Rewrite next to Layer2 Control.
2. In the Comment box, enter the comment.
3. Click Interface next to Bpdu Block.
4. Click Add new entry next to Interface.
5. In the Name box, enter the interface name.
6. In the Comment box, enter the comment.
7. Click Protocol next to interface.
8. In the Comment box, enter the comment.
9. Click Cdp next to Protocol.
10. In the Comment box, enter the comment.
11. Click Stp next to Protocol.
12. In the Comment box, enter the comment.
13. Click Vtp next to Protocol.
14. In the Comment box, enter the comment.
1. Click Traceoptions next to Layer2 Control.
2. In the Comment box, enter the comment for the traceoptions.
3. Click File next to Traceoptions.
4. In the Comment box, enter the comment for the file.
5. In the Filename box, enter the name of the file to receive the
output of the tracing operation.
6. In the Size box, enter the maximum size of each trace file, in
kilobytes (KB), megabytes (MB), or gigabytes (GB).
7. From the Files list, select the maximum number of trace files.
Range: 2 through 1000.
8. Select one of the following:
world-readable—To enable unrestricted file access.
no-world-readable—To restrict file access to owner. This
is the default setting.
9. In the Match box, enter the regular expression.
10. Click Add new entry next to Flag.
11. From the Name list, select the flag.
12. Select the Disable check box to disable the tracing operation.
Chapter 20: Configuring Protocols
265