Configuring A T640 Router On A Routing Matrix (Nsm Procedure); Table 49: Lcc Configuration Details - Juniper NETWORK AND SECURITY MANAGER 2010.4 - M-SERIES AND MX-SERIES DEVICES GUIDE REV 1 Manual

Configuring a T640 Router on a Routing Matrix (NSM Procedure)

Copyright © 2010, Juniper Networks, Inc.
To configure a T640 router on a routing matrix in NSM:
In the NSM navigation tree, select Device Manager > Devices.
1.
Click the Device Tree tab, and then double-click the device to select it.
2.
Click the Configuration tab. In the configuration tree, expand Chassis > Lcc.
3.
Add or modify settings as specified in Table 49 on page 107.
4.
Click one:
5.
OK—Saves the changes.
Cancel—Cancels the modifications.

Table 49: Lcc Configuration Details

Task
Configure the T640 routing
node.
Configure a port-mirroring
instance for the DPC and its
corresponding Packet
Forwarding Engines.
Your Action
1. Click Add new entry next to Lcc.
2. From the Name list, select the number that specifies a T640
router on a routing matrix.
Range: 0 through 3
3. In the Comment box, enter the comment.
4. Select one of the following:
online-expected—On a TX Matrix router, configures a T640
router so that if it does not come online, an alarm is sent to
the TX Matrix router. On a TX Matrix Plus router, configure a
T1600 router so that if it does not come online, an alarm is
sent to the TX Matrix Plus router.
offline—On a TX Matrix router, configures a T640 router so
that it is not part of the routing matrix. On a TX Matrix Plus
router, configure a T1600 router so that it is not part of the
routing matrix.
1. Click Fpc next to Lcc.
2. Click Add new entry next to Fpc.
3. From the Name list, select the slot number of the DPC.
4. From the Power list, configure the Flexible PIC Concentrator
(FPC) to stay offline or to come online automatically.
Chapter 11: Configuring Chassis
107