Configuring Ripng Protocol (Nsm Procedure); Configuring Ripng On The Router (Nsm Procedure) - Juniper NETWORK AND SECURITY MANAGER 2010.4 - M-SERIES AND MX-SERIES DEVICES GUIDE REV 1 Manual

M-series and MX-series Devices
Table 185: RIP Configuration Fields (continued)
Option
RIB Group
Send
Traceoptions

Configuring RIPng Protocol (NSM Procedure)

Configuring RIPng on the Router (NSM Procedure)

338
Function
The routing table group.
Enables you to configure RIP send
options.
Enables you to configure RIP protocol
level tracing options.
To have a router exchange routes with other routers, you must configure RIP next
generation (RIPng) groups and neighbors. RIPng routes received from routers not
configured as RIPng neighbors are ignored. Likewise, RIPng routes are advertised only to
routers configured as RIPng neighbors. See the following topics:
Configuring RIPng on the Router (NSM Procedure) on page 338
Configuring Graceful Restart for RIPng (NSM Procedure) on page 339
Configuring Group on page 340
Enable or Disable Receiving of Update Messages (NSM Procedure) on page 345
Configuring RIPng Send Update Messages (NSM Procedure) on page 346
Configuring RIPng Traceoptions (NSM Procedure) on page 346
To configure RIPng in NSM:
In the NSM navigation tree, select Device Manager > Devices.
1.
Click the Device Tree tab, and then double-click the device to select it.
2.
Click the Configuration tab. In the configuration tree, expand Protocols.
3.
Select Ripng.
4.
Add or modify settings as specified in Table 186 on page 339.
5.
Click one:
6.
OK—Saves the changes.
Cancel—Cancels the modifications.
Your Action
1. Expand the tree and select
RIP
.
Group
2. Specify the comment and ribgroup
name.
1. Expand the RIP tree and select
2. Specify the send options.
1. Expand the tree and select
RIP
.
Traceoptions
2. Expand the Traceoptions tree and set
up the file and flag parameters.
Copyright © 2010, Juniper Networks, Inc.
Rib
Send .