Configuring Class; Table 342: Class Configuration Details - Juniper NETWORK AND SECURITY MANAGER 2010.4 - M-SERIES AND MX-SERIES DEVICES GUIDE REV 1 Manual

M-series and MX-series Devices

Configuring Class

Table 342: Class Configuration Details

Option
System > Login > Class > class
Name
Comment
Access Start
Access End
Idle Timeout
Login Alarms
Login Script
Login Tip
550
Apply—Applies the login parameters.
You can configure the following options while configuring a system login:
Configuring Class on page 550
Configuring Password on page 551
Configuring Retry Options on page 552
Configuring User on page 553
To configure class:
In the NSM navigation tree, select Device Manager > Devices.
1.
Click the Device Tree tab, and then double-click the device for which you want to
2.
configure the class.
Click the Configuration tab. In the configuration tree, select System > Login > Class.
3.
Add or modify settings as specified in Table 342 on page 550.
4.
Click one:
5.
OK—Saves the changes.
Cancel—Cancels the modifications.
Apply—Applies the class settings.
Function
Specifies the login class name.
Supplies a descriptive comment for the class.
Specifies the start time for the remote access.
Specifies the end time for the remote access.
Specifies the maximum idle time before logging out.
Specifies the display system alarms when logging
in.
Specifies that you can execute this login script while
logging in.
Specifies the display login tip when logging in.
Your Action
Enter the login class name.
(Optional) Enter a comment.
Enter the start time in hh:mm format.
Enter the end time in hh:mm format.
Set the maximum idle time. Range: 0 -
4294967295.
Enable the Login Alarms check box to
enable this feature.
Enter a login script.
Enable the Login Tip check box to enable
this feature.
Copyright © 2010, Juniper Networks, Inc.