Configuring The Logical Demux Source Family Type On The Ip Demux Underlying Interface (Nsm Procedure); Procedure); Table 112: Ip Demux Configuration Details; Table 113: Ip Demux Source Configuration Details - Juniper NETWORK AND SECURITY MANAGER 2010.4 - M-SERIES AND MX-SERIES DEVICES GUIDE REV 1 Manual
Network and security manager
Table of Contents
Advertisement
M-series and MX-series Devices
216
Table 112: IP Demux Configuration Details
Task
Configure the logical
demultiplexing (demux)
destination family type.
Configuring the Logical Demux Source Family Type on the IP Demux Underlying
Interface (NSM Procedure)
You can configure the logical demultiplexing (demux) source family type on the IP demux
underlying interface using this option.
To configure logical demux source family type in NSM:
In the NSM navigation tree, select Device Manager > Devices.
1.
Click the Device Tree tab, and then double-click the device to select it.
2.
Click the Configuration tab. In the configuration tree, expand Interfaces.
3.
Select Interface.
4.
Add or modify settings as specified in Table 113 on page 216.
5.
Click one:
6.
OK—Saves the changes.
Cancel—Cancels the modifications.
Table 113: IP Demux Source Configuration Details
Task
Configure the logical
demultiplexing (demux)
source family type on the IP
demux underlying interface.
Configuring Epd Threshold for the Logical Interface (NSM Procedure)
To configure Epd threshold for the logical interface in NSM:
In the NSM navigation tree, select Device Manager > Devices.
1.
Click the Device Tree tab, and then double-click the device to select it.
2.
Your Action
1.
Click Add Interface next to Interface.
2. In the Add Interface Dialog box, enter the interface name.
3. Click Unit next to interface.
4. Click Add new entry next to Unit.
5. Click Demux Destination next to Unit.
6. Click Add new entry next to Demux Destination.
7. From the New demux-destination window, select the family
type.
Your Action
1.
Click Add Interface next to Interface.
2. In the Add Interface Dialog box, enter the interface name.
3. Click Unit next to interface.
4. Click Add new entry next to Unit.
5. Click Demux Source next to Unit.
6. Click Add new entry next to Demux Source.
7. From the New demux-destination window, select the family
type.
Copyright © 2010, Juniper Networks, Inc.
Advertisement
Table of Contents
