Juniper NETWORK AND SECURITY MANAGER 2010.4 - M-SERIES AND MX-SERIES DEVICES GUIDE REV 1 Manual page 486

M-series and MX-series Devices
450
Table 269: Traceoption BSG Configuration Details (continued)
Task
Configure trace options for
the signaling component of
the BSG.
Your Action
1. Click Add new entry next to Gateway.
2. Click Traceoptions next to gateway.
3. Click Flag next to Traceoptions.
4. Click Signaling next to Flag.
5. In the Comment box, enter the comment.
6. From the Minimum list, select the minimum trace level for all
signaling messages.
7. From the Sip Stack Wrapper list, select the trace options for
the glue layer that receives events from the SIP stack and
forwards them to the application and, conversely, receives
events from the application and forwards them to the SIP
stack.
8. From the b2b Wrapper list, select the trace options for entry
and exit to the BSG signaling application.
9. From the Ua list, select the trace options for the signaling
subcomponent that handles RECEIVE messages.
10. From the B2b list, select the trace options for the signaling
component that implements the b2b logic (translating
between dialogs, associating dialogs, creating new
downstream dialogs, and so on).
11. From the Topology Hiding list, select the trace options for the
signaling component that hides the network topology of a
network by CONTACT replacement and removal or
modification of certain headers.
12. From the Policy list, select the trace options for the signaling
component that applies policies for call admission, routing
decisions, security settings, and so on.
Copyright © 2010, Juniper Networks, Inc.