Table of Contents
Advertisement
Table 211: Configuring Maximum Paths Fields
Option
Comment
Limit
Log Interval
Threshold
Configuring Maximum Prefixes (NSM Procedure)
Copyright © 2010, Juniper Networks, Inc.
Enter the parameters as specified in Table 211 on page 375.
6.
Click one:
7.
OK—To save the changes.
Cancel—To cancel the modifications.
Apply—To apply the routing option settings.
NOTE: After you make changes to a device configuration, you must push that
updated device configuration to the physical security device for those changes
to take effect. You can update multiple devices at one time. See the Updating
Devices section in the Network and Security Manager Administration Guide for
more information.
Function
Specifies the comment for the maximum
path limit.
Indicates the maximum number of
routes. If this limit is reached, a warning
is triggered and additional routes are
rejected.
Indicates the minimum time interval (in
seconds) between log messages.
Specifies what is to be done when the
routing table reaches the maximum path
value. The options are:
None
threshold—Percentage of the
maximum number of routes when
installed, starts triggering the warning.
You can configure a percentage of the
Limit value that when reached starts
triggering the warnings.
log-only—Sets the route limit as an
advisory limit. An advisory limit
triggers only a warning, and additional
routes are not rejected.
You can configure a limit for the number of routes installed in a routing table based upon
the number of route prefixes in the table. .
To configure maximum prefixes limit in NSM:
Chapter 21: Configuring Routing Options
Your Action
Enter the comment.
Enter limit value or select a value from
the list.
Enter the log interval value or select a
value from the list.
1.
Expand the
Maximum Paths
select
.
Threshold
2. Select the radio-button.
tree and
375
Advertisement
Table of Contents
