Table of Contents
Advertisement
M-series and MX-series Devices
Configuring Service Filters (NSM Procedure)
170
Table 82: Prefix Actions Details
Task
Configure prefix-specific
actions.
A service filter identifies packets on which one or more services are to be applied, and
which PIC performs the service.
To configure the service filters for inet in NSM:
In the NSM navigation tree, select Device Manager > Devices.
1.
Click the Device Tree tab, and then double-click the device to select it.
2.
Click the Configuration tab. In the configuration tree, expand Firewall > Family > Inet.
3.
Click Prefix Action.
4.
Add or modify settings as specified in Table 83 on page 170.
5.
Click one:
6.
OK—Saves the changes.
Cancel—Cancels the modifications.
Table 83: Service Filter Configuration Details
Task
Configure service filter.
Your Action
1.
Click Prefix Action next to Inet.
2. In the Name box, enter the action name.
3. From the Policer list, select the actions to be taken.
4. Select the Count check box to include count as the action
modifier.
5. Select the Filter Specific check box to configure a policer to act
as a filter-specific policer.
6. From the Subnet Prefix Length list, select the subnet prefix length.
Range: 0 to 32
7. Click Source Prefix Length next to prefix-action.
8. Select source-prefix-length to configure the source address range
specified for a prefix-specific policer or counter and select the
source prefix length.
9. Select destination-prefix-length to configure the destination
address range specified for a prefix-specific policer or counter
and select the destination prefix length.
Your Action
1.
Click Service Filter next to Inet.
2. Click Add new entry next to Service Filter.
3. Expand service-filter.
4. In the Name box, enter the name that identifies the service
filter.
Copyright © 2010, Juniper Networks, Inc.
Advertisement
Table of Contents
