Table 265: New Call Usage Policy Set Configuration Details - Juniper NETWORK AND SECURITY MANAGER 2010.4 - M-SERIES AND MX-SERIES DEVICES GUIDE REV 1 Manual

M-series and MX-series Devices
442
Table 264: New Call Usage Policy Configuration Details (continued)
Task
Define the actions performed
on incoming requests that
match the new call usage
policy.
Configuring New Call Usage Policy Set (NSM Procedure)
To configure new call usage policy set in NSM:
In the NSM navigation tree, select Device Manager > Devices.
1.
Click the Device Tree tab, and then double-click the device to select it.
2.
Click the Configuration tab. In the configuration tree, expand Services > Border
3.
Signaling Gateway.
Select Gateway.
4.
Add or modify settings as specified in Table 265 on page 442.
5.
Click one:
6.
OK—Saves the changes.
Cancel—Cancels the modifications.

Table 265: New Call Usage Policy Set Configuration Details

Task
Configure a new call usage
policy set.
Your Action
1. Click Then next to From.
2. In the Comment box, enter the comment.
3. Select one of the following check boxes:
accept—To accept the traffic and send it to its destination.
reject—To reject the traffic and return a rejection message.
Rejected traffic can be logged or sampled.
trace—To trace messages accepted by this policy.
4. Click Media Policy next to Then.
5. In the Comment box, enter the comment.
6. Select the No Anchoring check box to disable or enable media
anchoring for the policy.
7. In the Service Class box, enter the name of the service class
to be applied to traffic that matches the new call usage policy.
8. Click Data Inactivity Detection next to Media Policy.
9. In the Comment box, enter the comment.
10. From the Inactivity Duration list, select the time interval that
determines inactivity.
Range: 30 through 3600
Your Action
1. Click Add new entry next to Gateway.
2. Click Sip next to gateway.
3. In the Comment box, enter the comment.
4. Click New Call Usage Policy Set next to Sip.
5. Click Add new entry next to New Call Usage Policy Set.
6. In the Name box, enter the identifier for the new call usage
policy set.
7. In the Comment box, enter the comment.
Copyright © 2010, Juniper Networks, Inc.