Configuring Topologies (Nsm Procedure); Configuring Traceoptions (Nsm Procedure); Table 219: Topology Configuration Details - Juniper NETWORK AND SECURITY MANAGER 2010.4 - M-SERIES AND MX-SERIES DEVICES GUIDE REV 1 Manual

Configuring Topologies (NSM Procedure)

Configuring Traceoptions (NSM Procedure)

Copyright © 2010, Juniper Networks, Inc.
For Multitopology Routing to run on the router, you need to configure one or more
topologies. For each topology, you specify a string value, such as voice, that defines the
type of traffic, as well as an interface family, such as IPv4. In addition, a default topology
is automatically created. You can also enable a topology for IPv4 multicast traffic. Each
topology that you configure creates a new routing table and populates it with direct
routes from the topology.
To configure topologies in NSM:
In the NSM navigation tree, select Device Manager > Devices.
1.
Click the Device Tree tab, and then double-click the device to select it.
2.
Click the Configuration tab. In the configuration tree, expand Routing Options.
3.
Select Topologies.
4.
Add or modify settings as specified in Table 219 on page 387.
5.
Click one:
6.
OK—Saves the changes.
Cancel—Cancels the modifications.

Table 219: Topology Configuration Details

Task
Configure topologies.
Configure the type of family
address type.
You can configure tracing operations for routing protocols to track all general routing
operations and record them in a log file. Any global tracing operations that you configure
are inherited by the individual routing protocols. To modify the global tracing operations
for an individual protocol, configure the tracing option when configuring that protocol.
To configure tracing options for routing protocols in NSM:
Chapter 21: Configuring Routing Options
Your Action
1. Expand Topologies.
2. In the Comment box, enter the comment.
1. Click Family next to Topologies.
2. Click Add new entry next to Family.
3. Expand key-chain.
4. From the Name list, select the type of family address type.
5. In the Comment box, enter the comment.
6. Click Topology next to family.
7. Click Add new entry next to Topology.
8. In the Name box, enter the name of the topology.
9. In the Comment box, enter the comment.
387