Configuring Probe (Nsm Procedure); Table 322: Routing Instance Configuration Options; Table 323: Probe Configuration Options - Juniper NETWORK AND SECURITY MANAGER 2010.4 - M-SERIES AND MX-SERIES DEVICES GUIDE REV 1 Manual

M-series and MX-series Devices

Table 322: Routing Instance Configuration Options

Option
Name
Comment

Configuring Probe (NSM Procedure)

Table 323: Probe Configuration Options

Option Function
Name Specifies the name of the owner.
Comment Specifies the comment for the probe.
probe > test
Name Specifies the name of the test.
Comment Specifies a comment for the test.
Probe Type Specifies the probe request type.
Probe Count Specifies the total number of probes per count.
Probe Interval Specifies the amount of time between the probes.
518
Apply—Applies the routing instances options.
Function
Specifies the routing instance name.
Specifies the comment for the routing instance.
This section provides information on configuring probe options for RPM.
To configure probe options:
In the NSM navigation tree, select Device Manager > Devices.
1.
Click the Device Tree tab, and then double-click the device for which you want to
2.
configure the probe mechanism.
Click the Configuration tab. In the configuration tree, select Services > Rpm > Probe.
3.
Add or modify settings as specified in Table 323 on page 518.
4.
Click one:
5.
OK—Saves the changes.
Cancel—Cancels the modifications.
Apply—Applies the probe options.
Your Action
Enter a name.
Enter a comment.
Your Action
Enter a name.
Enter a comment.
Enter a name.
Enter a comment.
Select the probe request type.
Enter the value or select it from the list.
Range: 1 through 15.
Enter the value or select it from the list.
Range: 1 through 255.
Copyright © 2010, Juniper Networks, Inc.