Table of Contents
Advertisement
M-series and MX-series Devices
Table 129: Damping Configuration Details
Option
Name
Comment
Disable
Half Life
Reuse
Suppress
Max Suppress
248
Add or modify the parameters as specified in Table 129 on page 248.
6.
Click one:
7.
OK—To save the changes.
Cancel—To cancel the modifications.
Apply—To apply the protocol settings.
NOTE: After you make changes to a device configuration, you must push that
updated device configuration to the physical security device for those changes
to take effect. You can update multiple devices at one time. See the Updating
Devices section in the Network and Security Manager Administration Guide for
more information.
Function
Specifies the name of the damping
parameter setting.
Specifies the comment for the damping
parameter setting.
Enables you to disable damping on a
per-prefix basis. Any damping state that
is present in the routing table for a prefix
is deleted if damping is disabled.
Indicates the time in minutes interval
after which the accumulated
figure-of-merit value is reduced by half
if the route remains stable.
Figure-of-merit values correlate to the
probability of future instability of a
device. Routes with higher
figure-of-merit values are suppressed
for longer periods of time.
Indicates the figure-of-merit value below
which a suppressed route can be used
again.
Indicates the figure-of-merit value above
which a route is suppressed for use or
inclusion in advertisements.
Indicates the maximum time in minutes
that a route can be suppressed no
matter how unstable it has been.
Your Action
Enter a name.
Enter a comment.
Select the check-box to disable
damping. Clear the check-box to enable
damping.
Enter the time limit in minutes or select
it from the list.
Enter the value or select it from the list.
Enter the value or select it from the list.
1.
Enter the time limit or select it from
the list.
2. Click OK.
Copyright © 2010, Juniper Networks, Inc.
Advertisement
Table of Contents
