Table of Contents
Advertisement
Copyright © 2010, Juniper Networks, Inc.
Table 166: Egress Router Address Configuration Details
Task
Specify the address of the
egress router.
Tracing LSP Packets and Operations (NSM Procedure)
You can trace LSP packets and operations using the Traceoptions option.
To trace LSP packets and operations in NSM:
In the NSM navigation tree, select Device Manager > Devices.
1.
Click the Device Tree tab, and then double-click the device to select it.
2.
Click the Configuration tab. In the configuration tree, expand Protocols > Mpls.
3.
Select Label Switched Path.
4.
Add or modify settings as specified in Table 167 on page 313.
5.
Click one:
6.
OK—Saves the changes.
Cancel—Cancels the modifications.
Table 167: LSP Traceoptions Configuration Details
Task
Trace LSP packets and
operations.
Your Action
1.
Click Add new entry next to Label Switched Path.
2. Click To next to label-switched-path.
3. Select one of the following:
To—Specify the egress router of a dynamic LSP and enter
the address of the egress router.
Template—Configure an LSP template.
Your Action
1.
Click Add new entry next to Label Switched Path.
2. Click Traceoptions next to label-switched-path.
3. In the Comment box, enter the comment.
4. Click File next to Traceoptions.
5. In the Comment box, enter the comment.
6. In the Filename box, enter the name of the file to receive the
output.
7. In the Size box, enter the maximum size of each trace file, in
kilobytes (KB), megabytes (MB), or gigabytes (GB).
8. From the Files list, select the maximum number of trace files.
Range: 2 through 1000
9. Select one of the following:
world-readable—To enable unrestricted file access.
no-world-readable—To restrict file access to owner.
Chapter 20: Configuring Protocols
313
Advertisement
Table of Contents
