Table of Contents
Advertisement
M-series and MX-series Devices
Configuring a Commit (NSM Procedure)
Related
Documentation
Configuring Diag Port Authentication (NSM Procedure)
540
You can configure a commit to automatically result in a commit and synchronize the
actions between dual routing engines within the same chassis.
To configure a commit:
In the NSM navigation tree, select Device Manager > Devices.
1.
Click the Device Tree tab, and then double-click the device for which you want to
2.
configure the commit.
Click the Configuration tab. In the configuration tree, select System > Commit.
3.
Enter a comment in the Commit workspace that describes the commit.
4.
Select the Synchronize check box in the Commit workspace, to synchronize the
5.
commit on both the routing engines.
Click one:
6.
OK—Saves the changes.
Cancel—Cancels the modifications.
Apply—Applies the commit settings.
Configuring a Diag Port Authentication (NSM Procedure) on page 540
Configuring a Domain Search (NSM Procedure)
Configuring a Backup Router (NSM Procedure) on page 539
You can configure passwords for performing diagnostics on the router's System Control
Board (SCB), System and Switch Board (SSB), Switching and Forwarding Module (SFM),
or Forwarding Engine Board (FEB) ports. This password provides an extra level of security.
To configure diag port authentication:
In the NSM navigation tree, select Device Manager > Devices.
1.
Click the Device Tree tab, and then double-click the device for which you want to
2.
configure the diag port authentication.
Click the Configuration tab. In the configuration tree, select System > Diag Port
3.
Authentication.
In the Diag Port Authentication workspace, enter a plain text password value.
4.
Click one:
5.
OK—Saves the changes.
Cancel—Cancels the modifications.
Copyright © 2010, Juniper Networks, Inc.
Advertisement
Table of Contents
