Table of Contents
Advertisement
M-series and MX-series Devices
436
Table 261: Session Policy Decision Configuration Details (continued)
Task
Specify the service class
term properties.
Configuring Service Point (NSM Procedure)
To configure session policy decision function in NSM:
In the NSM navigation tree, select Device Manager > Devices.
1.
Click the Device Tree tab, and then double-click the device to select it.
2.
Click the Configuration tab. In the configuration tree, expand Services > Border
3.
Signaling Gateway.
Select Gateway.
4.
Add or modify settings as specified in Table 262 on page 437.
5.
Click one:
6.
OK—Saves the changes.
Cancel—Cancels the modifications.
Your Action
1.
Click Term next to service-class.
2. Click Add new entry next to Term.
3. In the Name box, enter the identifier for the term.
4. In the Comment box, enter the comment.
5. Click From next to term.
6. In the Comment box, enter the comment.
7. Click Media Type next to From.
8. Click Add new entry next to Media Type.
9. In the New media-type window, select the type of media that
the service class matches.
any-media—Match all media types.
audio—Match audio traffic.
video—Match video traffic.
10. Click Then next to term.
11. In the Comment box, enter the comment.
12. Select the Reject check box to not accept the traffic and return
a rejection message.
13. From the Committed Information Rate list, select the maximum
bandwidth that can be allocated to a packet that is flowing
under normal line conditions.
Range: 0 through 2147483647
14. From the Committed Burst Size list, select the maximum
number of bytes allowed for incoming packets to burst above
the committed information rate.
Range: 20 through 2147483647
15. From the Dscp list, select the values for DSCP marking that the
BSG uses for traffic that matches the service class term.
Default: be
Copyright © 2010, Juniper Networks, Inc.
Advertisement
Table of Contents
