Configuring Radius Options (Nsm Procedure); Table 346: Port Configuration Details - Juniper NETWORK AND SECURITY MANAGER 2010.4 - M-SERIES AND MX-SERIES DEVICES GUIDE REV 1 Manual

M-series and MX-series Devices

Table 346: Port Configuration Details

Option Function
Ports > Auxiliary/Console
Comment Supplies a descriptive comment of the
auxiliary/console port.
Log Out On Disconnect Specifies that the console session logs out when
the cable is unplugged.
Disable Specifies that the auxiliary/console port is disabled.
Insecure Specifies that the super user access is not allowed.
Type Specifies the terminal type of the auxiliary/console
port.
Related
Documentation

Configuring RADIUS Options (NSM Procedure)

556
OK—Saves the changes.
Cancel—Cancels the modifications.
Apply—Applies the port configuration settings.
NOTE: You can either set auxiliary or console ports from the below table
descriptions.
Configuring PIC Console Authentication (NSM Procedure) on page 555
Configuring a Name Server (NSM Procedure) on page 554
Configuring a Login (NSM Procedure) on page 549
You can configure Remote Authentication Dial In User Service (RADIUS) options for the
NAS-IP address for outgoing RADIUS packets and password protocol used in RADIUS
packets.
To configure RADIUS options:
In the NSM navigation tree, select Device Manager > Devices.
1.
Click the Device Tree tab. Then double-click the device for which you want to configure
2.
radius options.
Click the Configuration tab. In the configuration tree, select System > Radius Options.
3.
Enter a comment in the Radius Options workspace that describes the RADIUS options.
4.
Your Action
(Optional) Enter a comment.
Select the Log Out On Disconnect check box
to enable this feature.
Select the Disable check box to enable this
feature.
Select the Insecure check box to enable this
feature.
Select a terminal type from the list.
Copyright © 2010, Juniper Networks, Inc.