Configuring Data Inactivity Detection (Nsm Procedure) - Juniper NETWORK AND SECURITY MANAGER 2010.4 - M-SERIES AND MX-SERIES DEVICES GUIDE REV 1 Manual

Copyright © 2010, Juniper Networks, Inc.

Configuring Data Inactivity Detection (NSM Procedure)

You can configure data inactivity detection to detect latch deadlocks or other media
inactivity on a gate.
To configure data inactivity detection on the router in NSM:
In the navigation tree select Device Manager > Devices.
1.
In the Devices list, double-click the device to select it.
2.
In the Configuration tab, expand Services > Pgcp.
3.
Select Gateway.
4.
Add or modify the settings as specified in Table 275 on page 466.
5.
Click one:
6.
OK—To save the changes.
Cancel—To cancel the modifications.
Chapter 23: Configuring Services
465