Juniper NETWORK AND SECURITY MANAGER 2010.4 - M-SERIES AND MX-SERIES DEVICES GUIDE REV 1 Manual page 316

M-series and MX-series Devices
Related
Documentation
280
Table 141: Link Management Protocol Configuration Details (continued)
Task
Represent a collection of
physical ports or time slots.
Specify trace options for the
LMP protocol.
Configuring the ILMI Protocol (NSM Procedure) on page 257
Your Action
1. Click Add new entry next to Te Link.
2. In the Name box, enter the name of the collection of physical
ports or the name of the time slots.
3. In the Comment box, enter the comment.
4. In the Local Address box, enter the local IP address associated
with the traffic engineering link.
5. In the Remote Address box, enter the remote IP address for
the traffic engineering link.
6. From the Remote ID list, select the ID assigned to a traffic
engineering link or an interface on the peer node.
Range: 1 through 4294967295
7. From the Te Metric list, select the metric value.
Range: 1 through 65535
8. Select Disable check box to disable the traffic engineering link
or an interface to a traffic engineering link.
9. Expand te-link.
10. Click Interface next to te-link.
Select interface to specify the egress router interface.
Select label-switched-path to specify the LSP to be used
by the forwarding adjacency.
1. In the Comment box, enter the comment.
2. Expand Traceoptions.
3. Click File next to Trace Options.
4. In the Comment box, enter the comment.
5. In the Filename box, enter the name of the file to receive the
output of the tracing operation. Enclose the name within
quotation marks.
6. In the Size box, enter the maximum size of each trace file in
kilobytes (KB), megabytes (MB) or gigabytes (GB).
7. From the Files list, select the maximum number of files.
8. Select world-readable to enable log file access to all users.
9. Select no-world- readable to prevent all users from reading
the log file.
10. Click Flag next to Trace Options.
11. Click Add new entry next to flag.
12. From the Name list, select a tracing operation to perform.
13. In the Comment box, enter the comment.
Copyright © 2010, Juniper Networks, Inc.