Juniper NETWORK AND SECURITY MANAGER 2010.4 - M-SERIES AND MX-SERIES DEVICES GUIDE REV 1 Manual page 498

M-series and MX-series Devices
462
Table 273: NAT Configuration Details (continued)
Task
Configure addresses and
ports for use in NAT Rules.
Specify the rule the router
uses when applying this
service.
Your Action
1. Click Port next to pool.
2. In the Comment box, enter the comment.
3. Expand Port.
4. Click Automatic next to Port.
5. Select one of the following:
automatic—To configure Router-assigned port.
range—To specify a range with minimum and maximum
values.
Range: 0 through 65535
1. Click Rule next to Nat.
2. Click Add new entry next to Rule.
3. In the Name box, enter the Identifier for the collection of terms
that comprise this rule.
4. In the Comment box, enter the comment.
5. From the Match Direction list, select the direction in which the
rule match is applied.
6. Expand Rule.
7. Click Term next to Rule.
8. Click Add new entry next to Term.
9. In the Name box, enter the identifier for the term.
10. In the Comment box, enter the comment.
11. Expand term.
12. Click From next to term.
13. In the Comment box, enter the comment.
14. Expand From.
15. From the listed match conditions, select the ones that are
applicable for Nat.
The match conditions listed are Application Sets, Applications,
Destination Address, Destination Address Range, Destination
Prefix List, Source Address, Source Address Range, and Source
Prefix List.
16. Click Then next to From.
17. Expand Then.
18. In the Comment box, enter the comment.
19. Select the Syslog check box to enable system logging.
20. Click No Translation next to Then.
21. Select one of the following:
no-translation—To specify that traffic is not to be translated.
translated—To define properties for translated traffic.
Copyright © 2010, Juniper Networks, Inc.